Wet Basements and Drainage: Pumps, Drains and Grading

Why basements get wet, how to move water away from the foundation, and how to size a sump pump and its backup from your own measurements.

Water reaches a basement by a small number of routes, and knowing which one you have decides everything else. Roof water arriving beside the wall, ground sloping the wrong way, groundwater rising under the slab, and a crack or penetration in the wall each behave differently. This hub covers the outside work that prevents most problems and the pump that handles whatever still arrives.

Start outside, every time

The cheapest fix is almost always grading and downspouts. A downspout serving 500 square feet of roof carries roughly 312 gallons for every inch of rain, and discharging that two feet from the wall simply delivers it to the foundation. Extend it, slope the ground away, and a surprising number of wet basements stop being wet. The Yard Drainage Grading Calculator works out the fall you need.

Subsurface drainage

Where surface work is not enough, drainage below ground intercepts water before it reaches the wall. An exterior French drain carries groundwater away in a gravel trench; interior drain tile collects water that has already reached the footing and routes it to a sump pit. The French Drain Material Calculator works out gravel, pipe and the fall across your run.

Sump pumps

A sump pump sits in a pit at the lowest point and lifts water away before it reaches the floor. Size it on total head rather than horsepower: the vertical lift plus friction in the pipe and fittings. Manufacturers quote headline flow at almost no lift, which is why reading the flow curve at your own head matters. Use the Sump Pump Sizing Calculator.

Backup is part of the system

Storms cause the water and the power cut at the same time, so a primary pump alone is half a system in a house that genuinely floods. A battery backup carries you through an outage of hours; a water-powered backup needs no electricity but uses municipal water and is not an option on a well. Size it with the Backup Runtime Calculator.

When water is already on the floor

Safety comes before cleanup. Water and electricity together are dangerous, so isolate power to the affected area before entering it, and follow the flood guidance from Ready.gov and the National Weather Service. Afterwards, drying matters quickly: EPA notes that mold can begin to grow on damp materials within 24 to 48 hours.

Start with these guides

Tools for this topic

Latest Wet Basements guides

New guides are added as they pass our fact-check. Browse everything in Wet Basements, or get new guides by email.

Sources we rely on

Frequently asked questions

Why does my basement only get wet after heavy rain?

That pattern points at surface and roof water rather than a high water table. Check the ground slope next to that wall and follow every downspout to where it actually discharges.


Do I need a French drain or a sump pump?

They solve different parts of the problem. A drain intercepts and carries water away; a pump lifts water that has already collected. Many houses with a real groundwater problem need both.


How far should a downspout discharge from the house?

Far enough that the water does not soak back toward the foundation, and downhill where the grade allows. Consider how many gallons one inch of rain delivers before deciding a short extension is enough.


Is standing water in a basement dangerous?

It can be. Isolate the power to that area before entering, because water and electricity together are a serious hazard. Never run a generator or a fuel-burning pump indoors.